Five Peugeot Keys Lessons From The Professionals

Peugeot 208 Key Replacement

Peugeot 208 key replacement should be left to experienced auto locksmiths with the right equipment and technical knowledge. They will be able to create and program new keys quicker than a dealership and at a cheaper cost.

A dead coin battery is most likely to be at fault the reason why your key fob isn't locking or unlocking doors. There are other reasons why the key may be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as making it impossible to start the engine. In this instance, you will need to choose the alternate method to start found in your vehicle's owner's manual.

The spark plugs may also be worn out. The spark plugs are responsible for instigating the fuel that ignites the engine. They have a limited lifespan. If they're not used enough to last, they'll eventually fail.

There is a simple solution to this problem. Check the voltage of the battery with a multimeter. If it's below 11.5 volts, then you need to replace it. It is also necessary to clean the battery's contacts when it has corrosion. This can be done by removing the rubber covers off the two terminals of the battery, and then using a wirebrush to eliminate any parts of the battery that are corroded. Then, reconnect the cables for the positive and negative poles.

Water Damage

If your 208 isn't starting and the battery is not flat then you should check whether the spark plugs are functioning. You might find that they're dirty and do not spark. This can be easily corrected by cleaning the spark plugs in a workshop.

Peugeot automobiles use a transponder style key that works with the car's immobiliser system. This ensures that only a valid key is able to turn the engine. If the chip inside the peugeot 208 key fob key is damaged, it will not transmit the proper signal to the vehicle.

Water damage is the most common cause of this problem. This is particularly common in colder climates where the vehicle could have been exposed to snow or rain. If this is the case, get in touch with a reputable locksmith who has all the tools and equipment needed to modify the new key. They will also have the latest technology and equipment required to create a Peugeot smart key. The process shouldn't take longer than 15 minutes.

Contacts to the battery are not working properly.

peugeot 207 new key programming replaced the transponder chips by introducing a new type that uses electronic components that are mounted on a circuitboard. The new system is great when it's new, but the circuit boards wear out over time and cease to function properly.

This could stop the immobiliser chip activating which means that your car won't start. If this happens it's recommended to call a peugeot 407 key fob (use this link) specialist or locksmith.

Another common issue is when the battery in the key fob is dying, this causes the blade of the key to stop being able to feed into the lock. A car locksmith will replace the battery and then cut a fresh blade for you. This is a simple fix.

Faulty Receiver Module

If your Peugeot key fob isn't working after dropping it on the ground, being exposed to a sudden rain or accidently washing it, it could be due to a faulty receiver module. The receiver is responsible for sending radio frequency signals to an on-board computer, which controls the central locking system within your Peugeot vehicle.

The key fob itself is fitted with rubber seals to prevent water from getting to the chip inside. The chip can be damaged by water when exposed to water for a prolonged period of time. The high salt content in the ocean or pool can cause damage to the key fob if it is submerged.

If your Peugeot spare key fob isn't working, you'll need to have the module replaced. This can only be performed by a professional auto locksmith or Peugeot specialist. peugeot boxer key keys are, unlike other vehicles, are protected by an immobilizer system. This requires the proper codes to start the car. This is why you should choose a reputable Peugeot locksmith for the job of designing and programming an alternative.

Computer on board is not working properly

The on-board computer in your Peugeot is responsible many functions in your car including airbags and power windows. The on-board computer will display a code if something goes wrong. The code will be stored in the system until the issue is resolved. This could mean that the on-board computers to be replaced.

The most frequent cause for the warning light for airbags to illuminate is corrosion or loose connections within the sensor. This can be caused by wear and tear, aging or exposure to moisture and salt. This issue should be addressed as soon as you can, since an airbag malfunctioning could be dangerous in the event of an accident.

If your Peugeot is showing a card not detected error then the key battery inside the key fob could be dead or weak. This will stop the key fob sending a signal to disarm the immobilizer on your vehicle. You can test this by pressing the unlock button on the key fob and then trying to start your car. If this doesn't work, the key battery is in need of replacement.